Ice Makers – Installation
|
|
Summary: Ice makers are one of those appliances one would love to have along with his or her refrigerators. There are external ice makers that can be connected to the refrigerator very easily without slightest strain and effort. All you need to take care is to gather the required tools to connect it. Just relax and patiently carry on the steps given and see wonders happening.
The best of the best
If you are looking for a lifetime leak-proof connection and believe in spending quite a huge amount for longer life, you can jump into soldering the joints. Now obviously you cannot disjoint it at any case in future. For the only thing you need to strain a bit is to get a reliable high quality flare fittings. Besides it is a bit hard for amateur owners. But long life is guaranteed once you are done with the connection. You just need to hunt for a flaring tool from suppliers. You now have a leak-proof connection of ice maker.
The other way out is to take the compression fitting as the connection type. Now this is very simple as you need to just follow simple steps and there is no flaring and stuff. You may think it’s a good one but think again as this will not make your connection leak proof. A hard and a careless pull at the disc and it results into a leak. Now, its upto you to decide which one is the best of the best.
Which one?
As of me, I have installed the compression fitting as it does not involve much effort and cost. It all works safe and good until a hard pull occurs on the copper pipelines. These are common in connecting toilets and sink faucets to valves and water supply lines. So hurry up and learn the basic hows’ of its installation.
So how do you do it?
The steps involve checking the length of the tube. It should be large enough to extend to the bottom of the tub. It is also mandatory to check that the pipe or tube coming out of the tub is straight. The basic thing that leads to a leak is the improper seating of the brass ferrule inside the compression fitting. So make sure of the above given steps and it becomes as simple as it sounds.
Flush the line first
Generally there is a risk of obstructing the free flow of water, as there might be all sorts of debris like solder beads, flux, wood chips, pipe burrs, etc. So it is recommended that you run at least 3 to 4 gallons of water through the pipeline before installing an ice maker or a toilet or a sink, as the case may be.
Slow leaks
I am sure you know that the compression fitting is not very reliable and develops leaks very often. The intensity may be a drop in 4 to 8 hours. Now this is really a matter of concern and you cannot afford to sit in ease. Make sure to place a towel or a newspaper underneath to check frequently.
|